Messages

I was trying to find my notes. I use sudo screen/dev/ttyUSB0 115200 When it just sits there with a blank screen cycle the power.
It's been while but I'll try to help. I also have a DEC850

OPNsense devices from the OPNsense shop use <ESC> to enter the bios and boot selection options.

Posted by: IHK
Thanks I may give that a shot

thanks for the reply, it is fully registered! 17 devices online 2 not seen

Device is not seeing all devices. I had to reinstall opnsense and zenarmor. Before the device was seen. Now it's not. Don't think I changed anything. suggestions for finding device? The device that is an apple ipad, also a network switch.

Thanks

I am by no means an X-pert! I discovered the same thing while looking at the log's. I had enabled opnsense admin page to wan. My setup had no business being setup that way. Control everything local lan.

Thanks for the reply, I guess I'll have to figure out the filters.

detected 14 and blocked 11 potentially harmful activities according to your rules. How do I find the detected harmful activities? Figure out if I should block them.

Thanks

The DEC850 is running fine after latest update. I'm no xpert but do have the 850. Let me know if I can help.

Now fixed for me also!

yes I have! I just gave up. There was an update available 14.3....In zenarmor dies at 30% multiple time! Got from opnsense check for update. No help, but let you know your not the only one...
hardware dec850     OPNsense 23.4.2-amd64

Thanks for the help

I have setup a new 850. looking for some performance tweaks. There are so many options with opnsense, I could use help.

Thanks

I have a DEC850. Trying to set things up. I am unsure about Hardware acceleration. AMD EPYC 3201 8-Core Processor (8 cores, 8 threads). I believe it will use acceleration.

Thanks for any help

I am using the os-wireguard, os-wireguard-go will not start. Gave up on the go version!

Thanks to the help of others in this group. I have the 850 installed. Last thing is to setup a VPN. When I install wireguard-go, It does not start! I can't find it in the log. Enable WireGuard is checked. Services show it as stopped.
Starting it just goes back to stop. The second wireguard will start. Just don't care for the warning about using it.

Thanks