Zotac nano ci323 LAN Problem

[razor1299]

Hello everyone my question is this. I have the Zotac nano ci323 with OPNsense 19.1.1-amd64. I have problem with my LAN connection, i cannot change 100baseTX to 1000baseTX but my WAN is running to 1000baseTX. I set my (Speed and duplex) to Autoselect for the WAN and the LAN.


You have ideas thank you for your help.

[newsense]

It would appear the port connecting to the LAN is either incapable or locked down to 100.

Try changing the cable as well, see if that yields different results.

[razor1299]

Hi,

Before my post i change the cable and i change the port in my Cisco Small Business Series 200 Series switch.

Thank you for your help.

[newsense]

And if you invert the ports on the Zotac do you see the same issue inverted or it doesn't change ?

[razor1299]

Hi,  i invert the ports on the Zotac my port 01 stay to 100baseTX...

Thank you.

[newsense]

Hi,  i invert the ports on the Zotac my port 01 stay to 100baseTX...

Thank you.

So if I understand correctly the port01 has an issue.

Is the behaviour consistent if you boot Ubuntu live on it ?

Also, any BIOS updates available or configuration switches that may lock down that port to 100 ?


If after all of the above you don't move any closer to the desired resolution, the last thing I'd do before RMA would be to unplug everything from it for a few minutes, BIOS reset or baterry removal if you have access inside the box, then check OPNsense/Ubuntu live one more time.