OPNsense Forum
English Forums => Hardware and Performance => Topic started by: razor1299 on February 25, 2019, 01:31:10 am
-
Hello everyone my question is this. I have the Zotac nano ci323 with OPNsense 19.1.1-amd64. I have problem with my LAN connection, i cannot change 100baseTX to 1000baseTX but my WAN is running to 1000baseTX. I set my (Speed and duplex) to Autoselect for the WAN and the LAN.
You have ideas thank you for your help.
-
It would appear the port connecting to the LAN is either incapable or locked down to 100.
Try changing the cable as well, see if that yields different results.
-
Hi,
Before my post i change the cable and i change the port in my Cisco Small Business Series 200 Series switch.
Thank you for your help.
-
And if you invert the ports on the Zotac do you see the same issue inverted or it doesn't change ?
-
Hi, i invert the ports on the Zotac my port 01 stay to 100baseTX...
Thank you.
-
Hi, i invert the ports on the Zotac my port 01 stay to 100baseTX...
Thank you.
So if I understand correctly the port01 has an issue.
Is the behaviour consistent if you boot Ubuntu live on it ?
Also, any BIOS updates available or configuration switches that may lock down that port to 100 ?
If after all of the above you don't move any closer to the desired resolution, the last thing I'd do before RMA would be to unplug everything from it for a few minutes, BIOS reset or baterry removal if you have access inside the box, then check OPNsense/Ubuntu live one more time.