"
WAN1 gateway is the default gatewy
WAN2 link disconnect, route table has default route,
then WAN2 link connect, no default route
WAN2 link disconnect, route table has default route,
then WAN2 link connect, no default route
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / MultiWAN issue
June 03, 2017, 04:41:53 AM
Hello everyone,
I setup MultiWAN and effective. It's normal from lan to internet, but when the wan(s) links change, I can not connect to internet from the gateway.
I view the route table use "netstat -rn", there are no default route .
I setup MultiWAN and effective. It's normal from lan to internet, but when the wan(s) links change, I can not connect to internet from the gateway.
I view the route table use "netstat -rn", there are no default route .
#3
General Discussion / Re: how can I build os-pptp plugins into the firmware?
March 17, 2017, 12:35:43 PM
Franco, thank you very much.
#4
General Discussion / Re: how can I build os-pptp plugins into the firmware?
March 14, 2017, 12:24:01 PMQuote from: fabian on March 14, 2017, 08:55:19 AM
all plugins have a root directory src which you can move inside the matching directory of core. In this case you must also update the dependencies of core.
hi fabian, thanks for your advice.
#5
General Discussion / Re: how can I build os-pptp plugins into the firmware?
March 14, 2017, 07:46:44 AM
anyone can give an advice? :)
#6
General Discussion / how can I build os-pptp plugins into the firmware?
March 13, 2017, 10:13:32 AM
hi, I have build the firmware from source, but I want to build os-pptp in the firmware,
how can I do?
Thanks!
how can I do?
Thanks!
Pages1
