Can't make VLAN work with TP-Link switch

[GiantJack]

Hello,

I have an opnsense routeur working fine with VLAN and a couple of netgear managed switch.

I just added a tp-link TL-SG105PE poe managed switch that I didn't succeed to configure for VLAN


Here is my setup
Opnsense :
Default LAN (192.168.1.x) +Vlan5  (192.168.5.x)

I use vlan5 for cameras

1st switch netgear:
Connected to opnsense with vlan1 untagged (Lan) +  vlan5 tagged. Pvid1
Connected to tp-link with  vlan1 (untagged) + vlan5 tagged , pvid1
Connected to camera1,  vlan5 untagged  pvid5 (works fine)

2nd switch tp-link
Connected to netgear vlan1 untagged, vlan5 tagged, pvid1
Connected to camera2 vlan5 untagged pvid5  (tried also pvid1) static ip on 192.168.5.x

I tried also tagged vlan1 between the 2 switches.

I cannot access camera2 on vlan5  whatever I try.

I don't know if tp-link switch either don't like opnsense or netgear switch or my configuration.

Any ideas?

[dseven]

You're probably going to get chastised for mixing untagged and tagged on the same links, but I don't believe that that's your issue here - at least from the OPNsense perspective.

Since it's working between OPNsense and Netgear, I don't think your issue has anything to do with OPNsense - either the TP-Link switch, or its link to the Netgear, has some issue...