Messages

Thank you weust for your time.
I download the 10.2 freebsd, which doesn't install neither.
So it must be a bug into FreeBSD/HYPER-V 2008 R2

But after searching the internet for half the day, I found a sollution here:

https://forum.pfsense.org/index.php?topic=109952.0
follow the steps from Moohouse let me install the system in HYPER-V 2008 R2

Tanks all
Detlef

Hi,
yes we can, give me a hint when.

OK I go back to 15.7.18 as boot image.
After booting it found the same disk, that 16.1 did not found.

Hi,
my VHD ist dynamic 50 GB.

When I press <E>xit die LiveCD runs.
There are no Interfaces shown, when I use syntetic network cards.
When I use legacy Cards, the adapters are shown.
I use Intel Gigagit-CT-Desktopadapters

thank you for reply,
ok I create a new machine with the following specs:
RAM 1024 MB static
CPU 1
HDD 60 GB on IDE
NET 1 (LAN) synthetic
NET 2 (WAN) synthetic
NET 3 (GUEST synthetic

Image: OPNsense-16.1.8-OpenSSL-cdrom-amd64.iso

After staring up and run installer, the following message comes up:
The installer could not find any disks suitable for installation (IDE or SCSI) attached
to this comupter....

Regards
Detlef

Hi, Im new to OPNsense
I used m0n0wall many yearrs for a guest net.
Now i tried to switch to OPNsense.
I decide to install it on HYPER-V 2008-R2.
First I installed 15.7.18. After reboot no network adapters are working. I had to enable each adapter by running ifconfig de... down ifconfig de... up.
A Firmwareupgrade to 16.1.8 run into a non working machine. After reboot it hungs into boot sequense.
So finaly I tried to install it in a fresh version.
during installation it does not find any disks. (Installer could not find any disks) 15.7.18 did.
Very strange.
Any idea hpw to fix?

Regards
Detlef