1
16.1 Legacy Series / [SOLVED] Installation on HYPER-V
« on: April 19, 2016, 02:44:53 pm »
Hi, Im new to OPNsense
I used m0n0wall many yearrs for a guest net.
Now i tried to switch to OPNsense.
I decide to install it on HYPER-V 2008-R2.
First I installed 15.7.18. After reboot no network adapters are working. I had to enable each adapter by running ifconfig de... down ifconfig de... up.
A Firmwareupgrade to 16.1.8 run into a non working machine. After reboot it hungs into boot sequense.
So finaly I tried to install it in a fresh version.
during installation it does not find any disks. (Installer could not find any disks) 15.7.18 did.
Very strange.
Any idea hpw to fix?
Regards
Detlef
I used m0n0wall many yearrs for a guest net.
Now i tried to switch to OPNsense.
I decide to install it on HYPER-V 2008-R2.
First I installed 15.7.18. After reboot no network adapters are working. I had to enable each adapter by running ifconfig de... down ifconfig de... up.
A Firmwareupgrade to 16.1.8 run into a non working machine. After reboot it hungs into boot sequense.
So finaly I tried to install it in a fresh version.
during installation it does not find any disks. (Installer could not find any disks) 15.7.18 did.
Very strange.
Any idea hpw to fix?
Regards
Detlef