Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ShaunHirst

#1
15.7 Legacy Series / Re: Load Balancing
December 04, 2015, 10:04:14 PM
so how would this work for 4 or 5 WAN ports.

i assume 3, 1, 1, 1 would result in 70%, 10% , 10% ,10%

Thanks in advance
#2
I've created an IPSEC tunnel phase 1 and 2 wav both connected but i'm unable to ping anything on the other side

when i check the routes the a route had been added to get to the remote network but using em0 which is my default gateway WAN1

so the peer network is 10.0.48.0/24 i would expect to see a route that routes this through the vPN but the route shows it going through the default gateway and if i trace route the trace showing it going through the default gateway then across the internet where it should have gone over the VPN tunnel.

also despite selecting a WAN interface in the phase 1 setup all the data was showing at the remote location as coming from the default route.

so for example i have 192.169.101.0/24 as a default gateway and 192.168.102.0 as a second wan i create ether VPN to use the 102 range but the remote site still sees me coming form the 101 address

Thanks in advance fro your help

Shaun