OPNsense
  • Home
  • Help
  • Search
  • Login
  • Register

  • OPNsense Forum »
  • Profile of ShaunHirst »
  • Show Posts »
  • Topics
  • Profile Info
    • Summary
    • Show Stats
    • Show Posts...
      • Messages
      • Topics
      • Attachments

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

  • Messages
  • Topics
  • Attachments

Topics - ShaunHirst

Pages: [1]
1
General Discussion / IPSEC Tunnel peer network being routed over default wan
« on: December 04, 2015, 09:54:55 pm »
I've created an IPSEC tunnel phase 1 and 2 wav both connected but i'm unable to ping anything on the other side

when i check the routes the a route had been added to get to the remote network but using em0 which is my default gateway WAN1

so the peer network is 10.0.48.0/24 i would expect to see a route that routes this through the vPN but the route shows it going through the default gateway and if i trace route the trace showing it going through the default gateway then across the internet where it should have gone over the VPN tunnel.

also despite selecting a WAN interface in the phase 1 setup all the data was showing at the remote location as coming from the default route.

so for example i have 192.169.101.0/24 as a default gateway and 192.168.102.0 as a second wan i create ether VPN to use the 102 range but the remote site still sees me coming form the 101 address

Thanks in advance fro your help

Shaun

Pages: [1]
OPNsense is an OSS project © Deciso B.V. 2015 - 2021 All rights reserved
  • SMF 2.0.17 | SMF © 2019, Simple Machines
    Privacy Policy
    | XHTML | RSS | WAP2