"
Sent.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Zenarmor (Sensei) / Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
February 09, 2022, 08:48:13 PM #2
Zenarmor (Sensei) / Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
February 08, 2022, 04:28:49 AM
I have VLANs, but only the physical LAN interface is set to protected.
#3
Zenarmor (Sensei) / Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
February 06, 2022, 08:03:40 PM
As the topic says, when I enable Zenarmor netmap puts the Mellanox into emulated mode in netmap which then stops passing any traffic, taking my OPNsense box offline on the LAN side. Any ideas on getting this functioning?
#4
Zenarmor (Sensei) / Re: Zenarmor 1.10.1 is out
January 26, 2022, 06:50:14 AM
Is anyone else having an issue with Mellanox ConnectX-3? If I enable Zenarmor it puts the Mellanox into emulated mode in Netmap, which brings down my LAN uplink to OPNsense.
#5
General Discussion / Re: UDP Broadcast Relay
January 24, 2022, 11:51:02 PM
Running 22.1.r2 and I'm having some difficulty getting it to run:
Are there any known compatibility issues known at this moment?
Code Select
2022-01-24T16:48:55-06:00
root /usr/local/etc/rc.d/os-udpbroadcastrelay: WARNING: failed to start osudpbroadcastrelayAre there any known compatibility issues known at this moment?
#6
23.7 Legacy Series / Re: [Tutorial/Call for Testing] Enabling Receive Side Scaling on OPNsense
January 24, 2022, 04:33:06 AM
Has anyone got this working with a Mellanox ConnectX-3?
Pages1
