Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.

[dtloken]

As the topic says, when I enable Zenarmor netmap puts the Mellanox into emulated mode in netmap which then stops passing any traffic, taking my OPNsense box offline on the LAN side. Any ideas on getting this functioning?

[sy]

Hi,

Do you have VLAN(s)? If yes are they protected as well?

[dtloken]

I have VLANs, but only the physical LAN interface is set to protected.

[sy]

Hi,

Please send a bug report from the upper right corner of Zenarmor GUI.

[dtloken]

Sent.