Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.

« previous next »

Print

Pages: [1]

Author Topic: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic. (Read 1696 times)

dtloken

Newbie
Posts: 6
Karma: 0

Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.

« on: February 06, 2022, 08:03:40 pm »

As the topic says, when I enable Zenarmor netmap puts the Mellanox into emulated mode in netmap which then stops passing any traffic, taking my OPNsense box offline on the LAN side. Any ideas on getting this functioning?

Logged

sy

Hero Member
Posts: 595
Karma: 44

Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.

« Reply #1 on: February 07, 2022, 03:54:40 pm »

Hi,

Do you have VLAN(s)? If yes are they protected as well?

Logged

dtloken

Newbie
Posts: 6
Karma: 0

Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.

« Reply #2 on: February 08, 2022, 04:28:49 am »

I have VLANs, but only the physical LAN interface is set to protected.

Logged

sy

Hero Member
Posts: 595
Karma: 44

Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.

« Reply #3 on: February 08, 2022, 02:53:25 pm »

Hi,

Please send a bug report from the upper right corner of Zenarmor GUI.

Logged

dtloken

Newbie
Posts: 6
Karma: 0

Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.

« Reply #4 on: February 09, 2022, 08:48:13 pm »

Sent.

Logged

Print

Pages: [1]

« previous next »