Messages

I disbaled: System: Settings: Logging / targets
Destination: UDP(4)   192.168.1.22 was checked. Don't know where it comes from, but it works.....

Hi everybody,

My /var/log/system/latest log is full of syslog-ng errors. Where can I find the solution?
Uninstalling and reinstalling is not a solution I read.
Its always an I/O error followed by a connection broken and then an open.

<43>1 2023-05-27T10:25:32+02:00 OPNsense.localdomain syslog-ng 34504 - [meta sequenceId="2"] I/O error occurred while writing; fd='7', error='Connection refused (61)'
<45>1 2023-05-27T10:25:32+02:00 OPNsense.localdomain syslog-ng 34504 - [meta sequenceId="3"] Syslog connection broken; fd='7', server='AF_INET(192.168.1.22:514)', time_reopen='60'

Thanks Hans

Also the default password opnsense does not work

HELP...
After my update to the latest version from 21.1.9 to 21.7, nothing happens. It rebooted after the update, then it was quiet. Connected it to mouse, keyboard and screen. Not even a bios on the display.
Connected it back in the network and tried to access it by ssh on the WAN and LAN ports. Ssh is enabled and worked previously. Unfortunally it doesn't allow me access.
Is there another way to access it by SSH?
Thx

Sounds like a hardware problem if you don't even see the BIOS screen or boot messages.

Also the default password opnsense does not work

UPDATE. old install was corrupt after update. New install boots.
Also, make sure when you connect a screen, its a small screen. 22inch is to big. 19inch works perfect

Also the default password opnsense does not work

HELP...
After my update to the latest version from 21.1.9 to 21.7, nothing happens. It rebooted after the update, then it was quiet. Connected it to mouse, keyboard and screen. Not even a bios on the display.
Connected it back in the network and tried to access it by ssh on the WAN and LAN ports. Ssh is enabled and worked previously. Unfortunally it doesn't allow me access.
Is there another way to access it by SSH?
Thx

Sounds like a hardware problem if you don't even see the BIOS screen or boot messages.

Also the default password opnsense does not work

I connected a display on the HDMI, but it gave 'no signal' on both ports. Then connect a LAN cable on WAN. I can ping the IP (192.168.1.3), but can't connect to it as root. SSH is enabled, and worked in the past with my known password.
Is there a way to reset it to factory default? Without access to SSH?

HELP...
After my update to the latest version from 21.1.9 to 21.7, nothing happens. It rebooted after the update, then it was quiet. Connected it to mouse, keyboard and screen. Not even a bios on the display.
Connected it back in the network and tried to access it by ssh on the WAN and LAN ports. Ssh is enabled and worked previously. Unfortunally it doesn't allow me access.
Is there another way to access it by SSH?
Thx