Messages

1

15.7 Legacy Series / Re: Load Balancing

« on: December 04, 2015, 10:04:14 pm »

so how would this work for 4 or 5 WAN ports.

i assume 3, 1, 1, 1 would result in 70%, 10% , 10% ,10%

Thanks in advance

2

General Discussion / IPSEC Tunnel peer network being routed over default wan

« on: December 04, 2015, 09:54:55 pm »

I've created an IPSEC tunnel phase 1 and 2 wav both connected but i'm unable to ping anything on the other side

when i check the routes the a route had been added to get to the remote network but using em0 which is my default gateway WAN1

so the peer network is 10.0.48.0/24 i would expect to see a route that routes this through the vPN but the route shows it going through the default gateway and if i trace route the trace showing it going through the default gateway then across the internet where it should have gone over the VPN tunnel.

also despite selecting a WAN interface in the phase 1 setup all the data was showing at the remote location as coming from the default route.

so for example i have 192.169.101.0/24 as a default gateway and 192.168.102.0 as a second wan i create ether VPN to use the 102 range but the remote site still sees me coming form the 101 address

Thanks in advance fro your help

Shaun