Home
Help
Search
Login
Register
OPNsense Forum
»
Archive
»
17.1 Legacy Series
»
Traffic shaper is not wroking for my 8/1 line
« previous
next »
Print
Pages: [
1
]
Author
Topic: Traffic shaper is not wroking for my 8/1 line (Read 6289 times)
abbas
Newbie
Posts: 1
Karma: 0
Traffic shaper is not wroking for my 8/1 line
«
on:
August 02, 2017, 03:38:19 pm »
I am trying here to configure traffic shaping for my 8/1 line.
I tried to test out simple rule to make sure it is working. I have put one pc in a queue with weight 1 and everyone else in a queue with weight 100. However this pc can download with a 1 Mb/s speed and any pc else download at around the same speed up to 3 Mb/s. Is this normal? and how should I configure it then if I want to put few PCs at higher priority than anyone else?
Pipe 1 :
bandwidth : 5300 Kbits
mask: destination
Scheduler type: FlowQueue-Codel
Enable CoDel: checked
queue 1:
pipe: pipe 1
weight: 1
mask: source
queue 100:
pipe: pipe 1
weight: 100
mask: source
rule 1:
seq: 11
interface: lan
dest: 192.168.103.10
target: qeue 100
rule 2:
seq: 21
interface: lan
dest: 192.168.103.10
invert destination: checked
target: queue 1
note: when I look at status I see this:
Limiters:
Limiters:
10000: 5.300 Mbit/s 0 ms burst 0
q75536 50 sl. 0 flows (1 buckets) sched 10000 weight 0 lmax 0 pri 0 droptail
sched 75536 type FIFO flags 0x1 256 buckets 0 active
mask: 0x00 0x00000000/0x0000 -> 0xffffffff/0x0000
10001: 650.000 Kbit/s 0 ms burst 0
q75537 50 sl. 0 flows (1 buckets) sched 10001 weight 0 lmax 0 pri 0 droptail
sched 75537 type FIFO flags 0x1 256 buckets 0 active
mask: 0x00 0x00000000/0x0000 -> 0xffffffff/0x0000
Queues:
q10000 50 sl. 0 flows (1 buckets) sched 10000 weight 1 lmax 0 pri 0 droptail
q10001 50 sl. 0 flows (1 buckets) sched 10000 weight 100 lmax 0 pri 0 droptail
«
Last Edit: August 02, 2017, 03:50:05 pm by abbas
»
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
Archive
»
17.1 Legacy Series
»
Traffic shaper is not wroking for my 8/1 line