Routing table does not load route received by OSPF

[bazbaz]

Hi,
I have a strange behavior. This Opnsense has OSPF enabled, that seems working well. It connects to remote OSPF routers, received data and create routing table. In routing -> diagnostic -> OSPF I can see the route I look for, and it reflect connections changes well.
For example, I have a remote network 10.0.0.0/24 that is connected via different paths, and I find the right entry in the table based on paths availability and priorities.

The problem is that the OPSENSE's routing table does not apply this. In system -> route -> status I do not find this entry. And every topology change is not reflected so I have routing problems.

This is really strange for me, but I cannot find a solution. Any idea?

thanks

[bimbar]

There is the OSPF state table, and then there is the system routing table. Routes from the one do not necessarily appear in the other, depending on your configuration.

It's hard to say much more without knowing more. And this stuff is notoriously tricky.

[bazbaz]

I think that system routing table may reflect (import) what the OSPF daemon calculates as routes. Is not this right?
What may I find as possible explanation of my problem?