Seeking Assistance for System Gateway Configuration Issue in Version 24.1

[hsing]

Hello everyone, I encountered a special situation in the new version 24.1. Regarding the System: Gateways: Configuration section, I noticed that once I assign a gateway, it essentially gets stuck there. If I try to delete it, the system won't allow me to perform any actions. After going into edit mode, if I attempt to disable it, I find that it cannot be saved. It wasn't until I activated advanced mode, which required filling in the Weight, that I was able to save. This temporarily resolves the issue of disabling, but as for deleting the gateway, has anyone else encountered the same issue as me?

Thank you.

[mimugmail]

Do you use multi-wan?

[hsing]

I remember that I probably didn't configure a backup gateway, but what I recall is that when I chose to edit the configured gateway, it kept prompting to enter a weight, which prevented the settings from being saved. Then, after setting the weight, pressing delete had no response.
So, I restored the machine back to version 23.7.12, re-downloaded the IOS, and re-setup the machine, after which this problem did not occur again.