Combine LAN & OPT?

[puddleglum]

I have a pc engines apu which I just installed opnsense on. It's got 3 ports. I've configured one for WAN which i'm using pppoe on, one for LAN doling out dhcp for my wired devices. How can I combine the remaining port with the LAN port? The APU sits next to a wireless access point and I would like to run the opt port to the wireless access point to have my wired and wireless devices all on the same subnet. Running a cable from the switch which is connected to the LAN port all the way back to the wireless access point isn't feasible.

[weust]

You could bridge LAN and Opt1.

[puddleglum]

Yes, I'm just not quite certain how to configure that.
Assign LAN & OPT IP addresses; create bridge of combined two; set dhcp server to use bridge instead of lan?

[weust]

No, you bridge ports. I would have too look into how it's done again.
Been too long to remember...

But it's probably under Interfaces.

[franco]

The bridge is created under Interfaces: Other Devices: Bridges. Add both interfaces and apply. Note that this creates a "rule-free" zone for traffic between the bridged devices.

[macafee]

try lagg.