OPNSense 23.1 suricata Keeps stopping.

[jlab]

Using 23.1 suricata will run for a bit, then just stop. Anything to obviously start looking at ?

[mimugmail]

Any logs via console?

[jlab]

Any logs via console?

I actually figured it out, since it was a test box, I installed 22.7 & updated, it did the same thing.

If i enable EVERY Rule Set, it causes issues.  Even on another box thats 200x more powerfull.

[mimugmail]

Better choose them wisely :)

[endurance]

For me surricata causes 100% on surricata and unbound as well after upgrade to 23.1. This even wo any rule activated
https://forum.opnsense.org/index.php?topic=32322.0

if there are any tipps to troubleshoot the behaviour it would be great.

[kinch]

similar issue with suricata after upgrade to 23.1_6. Suricata all rulesets are downloaded without ET PRO.
After boot opnsense successfully and everthing works fine, i have a disconnect on WAN after 5 mins(where is suricata running on) for around 5-10 seconds. this disconnct just happend once after ervery reboot after a uptime from around 5 min. After that, it runs for hours without issues.

edit: mb its bc suricata service starts a little bit delayed and when the service starts, its shutdown the WAN interface for a coupe of seconds.