AdGuard not updating

[opn_nwo]

I've always been able to upgrade AdGuard from within it's UI. Today there was a new update (v0.107.15), but for some reason it doesn't run. Instead, I get this message "Auto-update failed. Please follow these steps to update manually." redirecting me to https://github.com/AdguardTeam/AdGuardHome/wiki/FAQ#manual-update

[Vesalius]

Might be an issue on the adguard update server side. I get the same error for the v0.108.17 that came available today. I would give them a few hours to get things sorted and try again.

[tiermutter]

No problems here. Updated from 0.107.09 to 0.107.15 a few minutes ago.

[yeraycito]

Solution to Auto-update failed error when trying to install update 0.107.15 on Adguard Home:

1 - In Opnsense stop Adguard Home

2 - Donwload and unzip AdGuardHome_freebsd_amd64.tar.gz ( https://github.com/AdguardTeam/AdGuardHome/releases/tag/v0.107.15 )

3 - Access Opnsense via ssh to /usr/local/AdGuardHome and replace the old files with the new ones respecting the permissions of those files.

4 - In Opnsense launching Adguard Home

[opn_nwo]

Thanks for the suggestions. I'll wait a couple of days to see if it's an issue on their end. Then I'll attempt a manual update

[marvine]

No problems here just Updated to 0.107.15. ;)

[Inxsible]

please delete... posted in wrong thread by mistake.

[mimugmail]

I'm on the beta channel and on both systems it ran fine.
On one I had to refresh the page during update.

[ChrisChros]

same problem here. After clicking on the update button I directly receive the same message that the update-process failed.

[Vexz]

Had the same issue with AGH from the community repo. I ended up reinstalling AGH and then the update worked fine.

[athurdent]

Same on Ubuntu here, maybe not really an OPNsense/FreeBSD issue.

[Blackdragonx21]

Had the same issue with AGH from the community repo. I ended up reinstalling AGH and then the update worked fine.

Did the config (Blocklist etc.) lost after reinstall?

[RickNY]

I'm apparently on the beta channel running AdGuard Home v0.108.0-b.17 and it fails when I update from the UI to AdGuard Home v0.108.0-b.18..  I'll give it a few days, the updates from the UI had been working fine for months.

[Patrick M. Hausen]

I downloaded and extracted the FreeBSD release from here:
https://github.com/AdguardTeam/AdGuardHome/releases/download/v0.107.15/AdGuardHome_freebsd_amd64.tar.gz

Then copied the AdGuardHome binary to /usr/local/AdGuardHome/AdGuardHome, then rebooted just to make sure.

Working as it should.

[Vexz]

Had the same issue with AGH from the community repo. I ended up reinstalling AGH and then the update worked fine.

Did the config (Blocklist etc.) lost after reinstall?

Sadly the answer is yes. The better way to do it is as yeraycito described it above.