[SOLVED]Access Point(AP) web access between LAN and OPT

[Jose]

Hello, only have basic knowledge here regarding networking/firewall in general so I think this is the best forum section for asking such question/help, really sorry if should be in another sub forum.

I've recently switched from a basic OPNsense setup with just WAN + LAN, to WAN + LAN + OPT to have two routes, main one for my home LAB and secondary one for the rest of the house locations, since then I've been struggling trying to access from my workstation(192.168.1.200) the Access Point's located on the secondary route(192.168.2.1), I've followed several OPNsense how-to's around the net and read the OPNsense online manual but I was unsuccessful.

So the question is what should be the best way to do this, through NAT-Port-Forward, Firewall-Rule(s) or through Routing, also since an illustration can say a lot of things I will post an image of my setup for convenience.

Wanted scenario:
Gbe Client Admin want to access the Access Point's 192.168.2.10 and and 192.168.2.11 Web Interface, pretty sure after setting up access for one I will know how to do this for the rest, also 192.168.1.200 can ping OPT 192.168.2.1.

System specs:
OPNsense 22.7_4-amd64
FreeBSD 13.1-RELEASE
OpenSSL 1.1.1q 5 Jul 2022
CPU: i5-2390T
RAM: 8GB
Disk: 2.5" HDD/RootOnZFS

Setup diagram:

[Jose]

Hello, I've decided not to complicate myself with NAT/firewall rules/ect between two different ip/subnets in my home lab, so I've decided to just bridge the HP NC360T ports to act like an 2 port switch and stay with the default 192.168.1.1 for simplicity sake.

Will mark the OP as solved.