DEC850 webgui not accessible. How to address?

[grimelog]

I tried configuring a second lan port, and found afterwards I could not connect from lan port 0 again. port 0 used the default of 192.168.1.1, and port two was set to 192.168.1.2. I'm trying to connect over console with screen, but do not see an option that obviously corresponds to the console port under /dev. I don't have SSH enabled, as in the configuration wizard it sounded like it would be accessible through wan. Is it possible to connect directly with the console port still?

I see a little hole next to the power light. Is that for factory resetting? Is that my best option?

[franco]

Hi,

For serial access please see https://www.deciso.com/serial-console-access-boot-options/

Typically you should find the serial device with

# ls /dev/tty.*usbmodem*

Also 192.168.1.2 suggests you configured the same subnet for two ports which doesn't work without a bridge.


Cheers,
Franco

[grimelog]

Not seeing anything of that form. Must be the CK kernel. Must have not had the right modules loaded.