opnsens LAN can't use printer

Started by oliba, May 27, 2021, 04:57:04 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions
May 27, 2021, 04:57:04 AM Last Edit: May 27, 2021, 05:21:20 AM by oliba
Hello all,

I use Wizard：GeneralSetup，and Network setup is complete .
But  i can't use printer . What else needs to be set ?
thanks.

1.jpg
my printer stop screen. if firewall disable it work.
May 27, 2021, 05:12:49 AM #1 Last Edit: May 27, 2021, 12:27:21 PM by oliba
Quote from: oliba on May 27, 2021, 04:57:04 AM
Hello all,

I use Wizard：GeneralSetup，and Network setup is complete .
But  i can't use printer . What else needs to be set ?
thanks.

May 27, 2021, 11:49:23 PM #2
Your IP address is likely wrong. Your printer needs a 9 in the 3rd byte I think.
May 28, 2021, 04:05:24 AM #3
It looks like you are using 10.0.0.0/16, so your router has nothing to do with this connection problem; it should connect direct through the switch.

It appears you have one or more static IPs assigned because they are not sequential.  I would check these settings and subnet masks on both the printer and PC.  You can run an 'arp -a' command before/after a ping to see if the printer shows up. 
May 28, 2021, 08:02:48 AM #4
Quote from: rhubarb on May 28, 2021, 04:05:24 AM
It looks like you are using 10.0.0.0/16, so your router has nothing to do with this connection problem; it should connect direct through the switch.

It appears you have one or more static IPs assigned because they are not sequential.  I would check these settings and subnet masks on both the printer and PC.  You can run an 'arp -a' command before/after a ping to see if the printer shows up.

my pc ip config，gateway not core switch iP， ping printer is ok
iP address ： 10.0.9.20/24
gateway ： 10.0.9.2
Print
Go Up Pages1
User actions