firewall rule

[Aadolf]

hi all...
I have configed opnsense as bridge and set some rule for firewall when i disable a rule in GUI(it happens just when disable the rule) and apply setting i expected that the rule should be disable  but the effect of last rule was remain until i reboot the system...
Anyone else saw this situation or i have a mistake in bridge configuration...
(My problem is that i must reboot system to change the state of rule to disable.Its not important that the rule is pass or block .)

[slackadelic]

I've not had this issue with any of my firewall rules.

However, once you disable a rule, you must apply the changes for it to take effect without rebooting

[Aadolf]

My scenario is in bridge mode...Are you testing in bridge mode?

[slackadelic]

Negative.  I don't have a need for bridge mode at this time