DHCPv6 [LAN] Settings

[bimmerdriver]

I just did a clean reinstall of 21.1. Normally, I prefer to display lease times in local time, not UTC. I found the DHCPv4 [LAN] settings in the usual place, but when I looked for the DHCPv6 settings, I noticed there is no page for [LAN] settings. Have these settings been moved somewhere else?

[gpb]

Under Interfaces (for LAN), you probably need to tick the box to allow manual adjustment of dhcpv6 for it to show under services.

[bimmerdriver]

Under Interfaces (for LAN), you probably need to tick the box to allow manual adjustment of dhcpv6 for it to show under services.

Thank you for the reply. I did not know about this change in settings. Initially, I just enabled the manual mode and then noticed that DHCPv6 stopped working. I went into the DHCPv6 settings and enabled the server, but it still wasn't working. Finally, I noticed that RA was disabled.

IMO, it would be more straight-forward if enabling manual mode would cause the settings for DHCPv6 and RA to be set to the same settings as they were in auto-mode. They must have been abled in auto-mode, otherwise DHCPv6 would not have been working. Anyway, not a big deal...