OPNsense Forum
Archive => 21.1 Legacy Series => Topic started by: bimmerdriver on May 10, 2021, 05:12:54 am
-
I just did a clean reinstall of 21.1. Normally, I prefer to display lease times in local time, not UTC. I found the DHCPv4 [LAN] settings in the usual place, but when I looked for the DHCPv6 settings, I noticed there is no page for [LAN] settings. Have these settings been moved somewhere else?
-
Under Interfaces (for LAN), you probably need to tick the box to allow manual adjustment of dhcpv6 for it to show under services.
-
Under Interfaces (for LAN), you probably need to tick the box to allow manual adjustment of dhcpv6 for it to show under services.
Thank you for the reply. I did not know about this change in settings. Initially, I just enabled the manual mode and then noticed that DHCPv6 stopped working. I went into the DHCPv6 settings and enabled the server, but it still wasn't working. Finally, I noticed that RA was disabled.
IMO, it would be more straight-forward if enabling manual mode would cause the settings for DHCPv6 and RA to be set to the same settings as they were in auto-mode. They must have been abled in auto-mode, otherwise DHCPv6 would not have been working. Anyway, not a big deal...