Help needed, inter vlan routing

[jackydany]

Hi,

i am new to opnsense, never used it before, or pfense...
nut now i want my homelab to extend and therefore i upgrade a lot of my network and equipment.

as a result i divided my network into several vlans.
i have an aruba s2500 switch so i can configure vlans throughout my house.
also my rucuks wireless APs are vlan capable.

opnsense is running inside proxmox
wan configured on one interface of proxmox, lan on the other.
the lan interface in proxmox is a LACP bond which is vlan aware, this configuration is working. tried a vm with a interface in both networks, both reachable

what i dont understand is the way to use opnsense as a router for the inter-vlan traffic.
gateway between these vlans...

until now i used an old ddwrt router, wan side to one network (physically divided networks 192.168.1.x and 192.168.2.x) and lan side to the other, configured the router and thats it... communication between to networks. but after a power outtake the router is fried.... so i am forced (otherwise this would'nt have happend for a long time ) to set up opnsense.

i configured the wan, i configured the lan interface...
i configured the vlan with parent interface LAN

but how can i get my vlans to communicate?
i have a fritzbox (german router) doing dhcp and the internet connection. so i need to define a gateway for the 192.168.2.x network in this fritzbox router. but when i enter the opnsene static ip (192.168.1.158 LAN interface) it doesnt work.

what am i missing?

i need traffic between these to vlans.
rules are cloned from LAN interface in firewall.

hope you can help me out, willing to learn and read a lot but i cant find a solution for 2 days now. maybe i am searching for the wrong terms

thanks in advance!

[jackydany]

ok found help in another channel...

i had a mistake in the route on the "other side"... so just changed the ip there to the correct one and it works now...