OpenVPN Site to Site - Client MultiWAN no gateway group selection possible

[kostfastnix]

Hi to all OPNsense gurus,

i have running a scenario with OpenVPN site to site (tap => to use OSPF later). On the client site MultiWAN is running with PPoE and fixed IP. Gateway Group(s) are defined. Ini the OpenVPN Client Client Selection the Gateway Groups don't appear. OPNsense Version is 20.1.7. Is this behavior by design or did I make mistake(s).

Any suggestion welcome.

Kind Regards Bernd

[missionleben]

Hello,

Interesting. I have the same configuration. I would be interested in the answer as well. Every now and then the policy routing is referred to. But so far I have not found any instructions or the decisive tip on the Internet or here in the forum.  What definitely does not work is to use a gateway group as interface. This used to work with IPSEC but was abandoned in favor of policy based routing. Unfortunately, there is also very little information on how this should work now. As already written in the German forum, even the floating rules do not seem to work anymore. I.e. the tunnel is built up one level lower. Since also the binding to Localhost with a floating rule does not help.

regards

Christian

The scenario we are talking about here:

VPN                       LAN Outlet
|                _________|________
|     WAN1|                                  | WAN2
|                             Internet
V                                 |
                                   | WAN1
                            Datacenter
                                   |
                                LAN