IPSEC (NAT-T)

« previous next »

Print

Pages: [1]

Author Topic: IPSEC (NAT-T) (Read 3746 times)

MoonbeamFrame

Jr. Member
Posts: 71
Karma: 2

IPSEC (NAT-T)

« on: November 27, 2020, 11:27:41 am »

For a policy-based IPSEC between 2 OPNsense 20.7.5 boxes I have NAT-T disabled.

In the logs I can see both sides sending data on UDP/4500 which, as expected, is block at the other end.

Are there other configuration settings which affect NAT-T outside of the phase 1 configuration?

Logged

mimugmail

Hero Member
Posts: 6767
Karma: 494

Re: IPSEC (NAT-T)

« Reply #1 on: November 27, 2020, 12:04:38 pm »

Maybe better check IPsec.logs

Logged

WWW: www.routerperformance.net
Support plans: https://www.max-it.de/en/it-services/opnsense/
Commercial Plugins (German): https://opnsense.max-it.de/

MoonbeamFrame

Jr. Member
Posts: 71
Karma: 2

Re: IPSEC (NAT-T)

« Reply #2 on: November 27, 2020, 12:21:51 pm »

The logs show sending and receiving of UDP/4500

Logged

MoonbeamFrame

Jr. Member
Posts: 71
Karma: 2

Re: IPSEC (NAT-T)

« Reply #3 on: November 27, 2020, 12:28:27 pm »

OK I think I have it.

Using IKEv2. So NAT Traversal is always enabled.

But if NAT-T is disabled in the phase 1 proposal the inbound NAT-T is rejected (because the Automatically generated rule is not created).

« Last Edit: November 27, 2020, 12:44:16 pm by MoonbeamFrame »

Logged

Print

Pages: [1]

« previous next »