IP SEC, there is no traffic between the two networks

[litusbdn]

Good morning,
 
I have configured a point-to-point tunnel following this guide:  https://docs.opnsense.org/manual/how-tos/ipsec-s2s-route.html

The problem is that the vpn tunnel is successfully established, but I have no data traffic between one site (LAN1   192.168.1.x) and the other (LAN 2 192.168.3.X).


Any idea how I can allow traffic?

All Firewall rules (WAN and IPSEC interfaces) are configured on both sides.

I think it's a route problem, but I can't find the solution.


Thanks

[banym]

Hi litusbnd,

can you please provide screenshots from both sides configuration and firewall rules?
If possible could you draw some diagram to show the used networks and IPs aswell?

Without that information it is difficult to help you.