Upgrade from 19.7.2 to 19.7.3 causes internal interfaces to not access internet

[pyrodex]

So after today's install and tearing my hair out thinking it was something funky in ESXi I rebuilt my home firewall to bare metal.

After the install the WAN comes online and the firewall can ping 8.8.8.8 but internal clients can't and even sourcing the LAN interface on the firewall doesn't work.

After I did a:

Code: [Select]

opnsense-revert -r 19.7.2 opnsense

And then went into the LAN interface and simply hit SAVE and APPLY all my interfaces started to pass traffic (WAN + 4 internals).

I am not sure what happened but with opnsense 19.7.3 package the firewall isn't passing traffic across interfaces to WAN.

More than happy to provide any type of logs or whatever since I can reproduce it every time.

[tong2x]

mine is alittle different but having issue also with 19.7.3
my setup
2 wan (W1 and W2)
2 lan (LAN1 and Lan2/vlan15)

both can access the internet if using gateway
"default" , multiwan, or wan1
forcing wan2 as gateway will result to no Internet.

using tracroute diagnostic in "interfaces", opnsense, basically routes all trafic to wan1
even if I use wan2 as port to test the trace.
(I can see because all connect in traceroute uses the router ip of my wan1)

A little different but something is wrong with how it is routing and "choosing" the gateway.
(wan2 is functional if I directly access the modem)

FIXED:
I fixed my issue with WAN2 by removing wan2 interface (gateway groups and the WAN2 interfece itself etc..), then setting it up again...
now in tracerout the correct router(modem2) is being used. maybe a bad setting somewhere on upgrade that cause it to incorrect route wan2 to wan1