[SOLVED] How to read Health -> Quality graph

[moonman]

I understand that the latency for example is 15ms, but what is 400m for packet loss?

[franco]

Loss is in percent, 400m to 1 is 40% loss. The graph shares the y-axis with the millisecond values so it's a little hard to read indeed.


Cheers,
Franco

[Northguy]

Does the graphical package offer a secondary y scale? Maybe it can be easily plotted in, making the graph easier to read?

[franco]

I don't believe it does. RRD is relatively simplistic and static in these matters.


Cheers,
Franco

[moonman]

Loss is in percent, 400m to 1 is 40% loss. The graph shares the x-axis with the millisecond values so it's a little hard to read indeed.


Cheers,
Franco

Thanks. Makes sense.

[NKnusperer]

Loss is in percent

Can you please describe what exactly this percentage mean?
For example I have a loss of up to 1.3 with a delay of 15, so 130% loss?. How do I interpret this?
I'm a bit confused  ;D

[franco]

Loss is in percent, 400m to 1 is 40% loss.

This seems rather self explanatory? I don't know what "1.3" is. Screenshot please.


Cheers,
Franco

[chemlud]

I do such graphs on a daily basis, the y-axis is.. improvable... I would have ms on the left and %loss on the right. Then it would be fool-proof.

Or if you have only one y-axis in your graphing tool, choose ms and %loss on the same y-axis. No "400m" which is ambiguous at best. 

[NKnusperer]

Loss is in percent, 400m to 1 is 40% loss.

This seems rather self explanatory? I don't know what "1.3" is. Screenshot please.


Cheers,
Franco

See attached screenshot with a value of 1.9 up to 3.3

[NKnusperer]

*bump*
Might this be a rendering bug in the graph and 1.9 is actually 1.9m or something?
Is there a way to see the raw values generated by dpinger?

[franco]

Thanks for the screenshot. Depending on the graph interval I get a loss of up to 18 aggregated, basically higher with each interval increase. I think that either rrd is treating these values incorrectly or they are actually set up incorrectly or a mix of both (these are not package counters/bytes that can add up).

Does the value drop if you switch the resolution to "high"?


Cheers,
Franco

[NKnusperer]

Does the value drop if you switch the resolution to "high"?

No, it actually increase, see attached screenshots.

[NKnusperer]

Just a quick follow-up on this:
On Monday there was a WAN outage and during this time the loss peaked to 100 (see attached screenshot).
I think this confirms that the reported value is indeed the raw percentage as logged by dpinger ranging from 0 to 100 and not 0 to 1.
What do you think?

[chemlud]

...that should be quite easy to simulate, just pull the WAN cable. why does nobody know what the numbers mean? :-O