Author Topic: firewall rule (Read 4341 times)

Aadolf · « **on:** March 02, 2016, 02:45:55 pm »

hi all...
I have configed opnsense as bridge and set some rule for firewall when i disable a rule in GUI(it happens just when disable the rule) and apply setting i expected that the rule should be disable but the effect of last rule was remain until i reboot the system...
Anyone else saw this situation or i have a mistake in bridge configuration...
(My problem is that i must reboot system to change the state of rule to disable.Its not important that the rule is pass or block .)

slackadelic · « **Reply #1 on:** March 02, 2016, 04:54:52 pm »

I've not had this issue with any of my firewall rules.

However, once you disable a rule, you must apply the changes for it to take effect without rebooting

Aadolf · « **Reply #2 on:** March 03, 2016, 07:27:58 am »

My scenario is in bridge mode...Are you testing in bridge mode?

slackadelic · « **Reply #3 on:** March 03, 2016, 10:10:55 pm »

Negative. I don't have a need for bridge mode at this time

Author Topic: firewall rule (Read 4341 times)

Aadolf

firewall rule

slackadelic

Re: firewall rule

Aadolf

Re: firewall rule

slackadelic

Re: firewall rule