Navigate the wireguard subnet

[mauro]

Dear all,
I got stuck somewhere with Wireguard and can't get my head around.

I've installed wireguard and set up an instance which I can reach and connect to. I can ping the WG server with no problem

At the moment I can't connect to the other machines connected to the same WG instance. If I try to ping the IPs all packets are lost. every PC can instead ping the server and revers.

I followed the official OPNSense tutorial but still no clue about why this is happening

Does anyone have sone leads to follow?

thanks

[Patrick M. Hausen]

For a hub and spoke topology and e.g. a /24 for the tunnel network:

* on the hub/central instance configure e.g. 192.168.100.1/24 as the tunnel address
* on the spokes/clients configure e.g. 192.168.100.2/32, 192.168.100.3/32, etc. as the respective tunnel addresses
* on the hub place e.g. 192.168.100.2/32 in AllowIPs for the first client, 192.168.100.3/32 for the second, etc.
* on the clients place 192.168.100.0/24 in AllowedIPs

HTH,
Patrick

[mauro]

thanks Patrick for your prompt reply.

I think I have the settings correct as far as I can connect to the server and ping it with no problem. By all mean, I list below briefly my configuration but unfortunately I don't know where the proper config files are stored

Server side
Instance setting

Code: [Select]

Name: wg1
public and private key self generated
Port: 51820
tunnel address: 192.168.2.1/24
Peers: list of peer I allow to connect to this instance

Peer setting (one for all)

Code: [Select]

name: wg1_peer1
public key: as generated by the client
allowerIPs: 192.168.2.100/32 (the other peers have different IPs but same subnet)
endpoint address: blank
Endpoint port: blank
Instance: wg1

Local config file (wg1_peer1):

Code: [Select]

[Interface]
PrivateKey = XXXXXXXX
Address = 192.168.2.100/32


[Peer]
PublicKey = YYYYYYYY
AllowedIPs = 192.168.2.0/24
Endpoint = example.domain:51820

my doubt now about this issue is a forwarding problem. I have also an openvpn server set up and I can surf the openvpn net but obviously on different IPs. Is there anything I might need to specify to wireguard instance?

Regarding firewall rule, there is only one under the wg1 instance which allow everything from everyere

Cheers

[mauro]

Hi there,

still working on it and further helps are welcome

After checking around I thoungt that assigning IP as X.X.X.X/32 to peers will cause the issue.

I changed all confs but it seams nothing has reall changed so I was possibly wrong.

Thanks for helping

[chemlud]

You only have the tunnel net in the "Allowed IP" section of the config. If you add the remote net(s) you will be able to reach them via WG.