Separate IPSEC VTI per Phase 1

« previous next »

Print

Pages: [1]

Author Topic: Separate IPSEC VTI per Phase 1 (Read 1860 times)

throwaway26a

Newbie
Posts: 8
Karma: 0

Separate IPSEC VTI per Phase 1

« on: May 08, 2021, 05:08:56 pm »

Is it possible to have a separate Virtual Tunnel Interface per Phase 1? E.g. with IPSEC actively working with 1 or more IPSEC connections to different locations, the VTI created is 'enc0'. This makes monitoring with NMS difficult since the only interface being reported by SNMP is 'enc0'

Logged

mimugmail

Hero Member
Posts: 6766
Karma: 494

Re: Separate IPSEC VTI per Phase 1

« Reply #1 on: May 08, 2021, 06:20:09 pm »

With every Route based IPsec you get a new ipsecX device.

Logged

WWW: www.routerperformance.net
Support plans: https://www.max-it.de/en/it-services/opnsense/
Commercial Plugins (German): https://opnsense.max-it.de/

throwaway26a

Newbie
Posts: 8
Karma: 0

Re: Separate IPSEC VTI per Phase 1

« Reply #2 on: May 08, 2021, 06:36:25 pm »

I see the con0/1 interfaces under the ipsec config but those probably aren't polled since they aren't a VTI. I've checked 'Do not install routes' to see if I could force a change but that doesn't seem to be working. I still only have the enc0 showing up as the ipsec interface if I check with ifconfig.

Logged

Print

Pages: [1]

« previous next »