DHCPv6 [LAN] Settings

Started by bimmerdriver, May 10, 2021, 05:12:54 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions
May 10, 2021, 05:12:54 AM
I just did a clean reinstall of 21.1. Normally, I prefer to display lease times in local time, not UTC. I found the DHCPv4 [LAN] settings in the usual place, but when I looked for the DHCPv6 settings, I noticed there is no page for [LAN] settings. Have these settings been moved somewhere else?
May 10, 2021, 04:38:21 PM #1
Under Interfaces (for LAN), you probably need to tick the box to allow manual adjustment of dhcpv6 for it to show under services.
HP T730/AMD  RX-427BB/8GB/500GB SSD
HP NC365T 4-PORT
May 10, 2021, 09:57:26 PM #2
Quote from: gpb on May 10, 2021, 04:38:21 PM
Under Interfaces (for LAN), you probably need to tick the box to allow manual adjustment of dhcpv6 for it to show under services.
Thank you for the reply. I did not know about this change in settings. Initially, I just enabled the manual mode and then noticed that DHCPv6 stopped working. I went into the DHCPv6 settings and enabled the server, but it still wasn't working. Finally, I noticed that RA was disabled.

IMO, it would be more straight-forward if enabling manual mode would cause the settings for DHCPv6 and RA to be set to the same settings as they were in auto-mode. They must have been abled in auto-mode, otherwise DHCPv6 would not have been working. Anyway, not a big deal...
Print
Go Up Pages1
User actions