OPNsense
  • Home
  • Help
  • Search
  • Login
  • Register

  • OPNsense Forum »
  • Profile of olest »
  • Show Posts »
  • Messages
  • Profile Info
    • Summary
    • Show Stats
    • Show Posts...
      • Messages
      • Topics
      • Attachments

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

  • Messages
  • Topics
  • Attachments

Messages - olest

Pages: [1] 2 3
1
General Discussion / WAN packet loss
« on: September 18, 2020, 01:20:18 pm »
Hi,

When I go to System -> Gateways -> Single I see a packet loss of 0.0% but when I go to Reporting -> Health -> Quality I see a loss of 100-200m.

How should I read those data?

2
General Discussion / Re: Postfix problem
« on: June 07, 2020, 07:29:06 pm »
Yes. Only email from ebay have this problem so far.

3
General Discussion / Postfix problem
« on: June 07, 2020, 05:09:19 pm »
Have setup Postfix with rspamd, redis and clamav.

When receiving emails from ebay (only so far) I get the email but ebay resend it again many times.

In the log I get this:
postfix/smtpd[82980]: disconnect from mxphxpool2041.ebay.com[66.211.185.204] ehlo=2 starttls=1 mail=1 rcpt=1 data=0/1 commands=5/6

Is it a timeout problem in some of the components or how do I fix it?

4
General Discussion / Re: Postfix and Lets Encrypt
« on: June 07, 2020, 11:26:48 am »
done

5
General Discussion / Re: Rspamd webGUI
« on: June 07, 2020, 10:09:18 am »
Used: rspamadm pw and changed /etc/rspamd/local.d/worker-controller.inc

Is there a CLI command set set it directly?

6
General Discussion / Rspamd webGUI
« on: June 07, 2020, 09:45:18 am »
Installed rspamd and created NAT rule to access port 11334 from LAN but how do I set the rspamd webgui password?

7
General Discussion / Postfix and Lets Encrypt
« on: June 07, 2020, 08:54:58 am »
I have setup Postfix on opnsense to use Lets Encrypt certificate generated by acme plugin but how do I restart the postfix server when the certificate is renewed?

8
General Discussion / IPSEC backup remote gateway
« on: May 19, 2020, 09:42:49 am »
Is it possible to setup at backup remote gateway in phase1 of an IPSEC tunnel?

9
General Discussion / Dual WAN failover
« on: May 18, 2020, 11:34:07 am »
What will I gain from using a Gateway Group instead of just setting Priority on the single Gateways?
I just need failover.

10
20.1 Legacy Series / Re: Getting just around ~200Mbit of 1Gbit Bandwidth
« on: April 26, 2020, 09:02:35 am »
Looks like that is what your hardware can handle:
https://wiki.ipfire.org/hardware/pcengines/apu1c

11
Intrusion Detection and Prevention / Re: Problem with access between LAN and LAN_VLAN with IPS
« on: August 06, 2019, 08:34:28 am »
Yes "Promiscuous mode" is the problem.
Should I still only select LAN interface in IPS settings to get IPS on VLAN interfaces?


Tried to disable VLAN Hardware filtering also but no change.

12
General Discussion / Re: Issue about NAT in S2S VPN
« on: July 05, 2019, 07:43:03 am »
It is only working if you use id type ip adress.

13
Intrusion Detection and Prevention / Problem with access between LAN and LAN_VLAN with IPS
« on: June 24, 2019, 12:07:13 pm »
When I enable IPS on LAN interface and use "Promiscuous mode" I cannot access my Synology NAS at LAN_VLAN1200 from a PC at LAN.

14
19.1 Legacy Series / Re: Cron job not running
« on: June 24, 2019, 12:03:45 pm »
Sorry - did not see your post.

A reboot fixed it.

15
Intrusion Detection and Prevention / Re: [ERRCODE: SC_ERR_PCAP_DISPATCH(20)] - error code -2
« on: June 18, 2019, 10:07:18 pm »
My fault - had selected VLAN interface...

Pages: [1] 2 3
OPNsense is an OSS project © Deciso B.V. 2015 - 2021 All rights reserved
  • SMF 2.0.17 | SMF © 2019, Simple Machines
    Privacy Policy
    | XHTML | RSS | WAP2