Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - n725

#1
Italian - Italiano / Re: Opnsense e nic multiporta
February 24, 2023, 09:19:17 AM
nessuno?
#3
I am definitely new to the world of BSD and Opnsense. I bought a Futro S920 (which has one onboard NIC) and added a multi-port NIC (4) to it. I installed Opnsense and configured the WAN on the native port re0. Everything works fine until I start to configure the other four ports. I configure re0 as WAN with IP 192.168.10.100/24, and physically connect it to the router, a Fritzbox. It is configured as a completely exposed host on the Fritzbox, and everything is fine so far. I can connect to the host and configure various options through the GUI.

As soon as I assign an IP, for example 10.168.10.100/24, to one of the other four ports, for example em0, configuring it as lan1 and connecting it to a switch, the machine stops responding, and the only way to make it responsive again is to connect the machine to a monitor and reset the settings (I haven't tried via serial). Can anyone clarify if I am making a mistake or if there is something really wrong?
#4
Italian - Italiano / Opnsense e nic multiporta
February 22, 2023, 12:53:52 PM
Buongiorno all.
Sono decisamente nuovo al mondo BSD ed a opnsense.
Ho preso un futro s920 (che ha una nic onboard) e gli ho piazzato dentro una nic multiporta (4).
Ho installato opnsense e configurato la wan sulla porta natia re0. Funziona tutto finchè non inizio a configurare le altre quattro porte. La re0 la configuro come wan con ip 192.168.10.100/24, ed è collegata fisicamente al router, un fritzbox. Viene configurata come host completamente esposto sul fritxbox. E fin qui tutto bene. riesco a collegarmi sull'host e configurare le varie opzioni tramite gui. Non appena assegno ad una una qualsiasi delle altre quattro porte, ad esempio em0, un ip, ad esempio 10.168.10.100/24, configurandola come lan1 e collegandola ad uno switch, la macchina smette di rispondere, e l'unico modo per renderla nuovamente responsiva, è quello di collegare la macchina ad un monitor e resettare le impostazioni (via seriale non ho provato). Qualcuno potrebbe delucidarmi se sto commettendo un errore o se c'è qualche cosa che realmente non va?