Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - jorgegmayorgas

#1
Hello
I recently upgraded my FTTH from 300 to 600 mb. 
In order to do that I have to change from previous ISP to O2. O2 has and all in one device (Mitrastar GPT-2541GNAC) to handle phone and internet connection ( I have no IPTV) .
In OPNsense previous ISP connection was using DHCP, with O2  connection is PPPoE as all in one device  is on bridge mode . VLAN for VoIP and Internet is  still managed by all in one device.
VoIP is working without issues.
Opnsense is virtualized on a i5-2500s with 16gb with Vmware. VM for Opnsense has assigned 2 cores and 4 gb, net driver is vmxnet3.
I have connectivity and it is OK but it seems 600 mb is not possible.
If I try a speedtest from any site available on the internet I can see a message on freebsd screen :
"interrupt storm irq detected on irq266 : throttling interrupt source"
"interrupt storm irq detected on irq257 : throttling interrupt source"

vmstat -i shows those irqs are lan and wan

interrupt                          total       rate
irq1: atkbd0                           6          0
irq15: ata1                        31467          1
irq17: mpt0 ehci0                  85205          2
irq18: uhci0                       82599          2
cpu0:timer                       3082269         65
cpu1:timer                       2862490         61
irq257: vmx0                     2525995         54
irq266: vmx1                     4007046         85
Total                           12677077        269



Shutting down Opnsense and checking with a  Dlink router model DIR-842 (PPPoE connection , same as Opnsense) , speedtest results are way better but the logging capabilities of this device are limited or I don't know how to check if device is really throttling or not

My understanding is that my computer hardware used in Opnsense exceeds D-link hardware specs, maybe I am wrong

Full specs
Intel i5-2500s
Gigabyte 1155 Motherboard (GA-H77-DS3H) , latest BIOS
16GB DDR3 1600 Mhz Crucial Ballistix (2x8gb)
Quad Gigabit Intel i340-T4 dedicated to VM (driver version installed is 5.3.5.42, DKMS built)
Intel Corporation 82572EI Gigabit Ethernet Controller (for Openmediavault omly)
3 TB Toshiba 7200 RPM HDD
320 GB Seagate 7200 RPM HDD
SSD 240 GB Kingston (boot drive)
Openmediavault 4.1.35-1
Kernel 4.19.0-0.bpo.6-amd64 #1 SMP Debian 4.19.67-2+deb10u2~bpo9+1 (2019-11-12) x86_64 GNU/Linux
Vmware player version 14.1.7

Does anyone have suggestions or ideas to avoid throttling?

Best regards,
Jorge Giménez
#2
Hardware and Performance / APU2C4 vs I3 7100t
January 22, 2018, 02:58:10 PM
Hello

I am planning to build an Opnsense low power router but I am not able to decide between Apu2c4 (will add a new 120 GB msata)or an i3 7100t (45w) + Asrock H270 ITX that has Intel dual lan(I already have case,psu ,1 HP NC360T Dual port NIC and 60 Gb SSD). My internet connection is  300/300 FFTH. Concurrent users will be from 2 to 5. I am evaluating VPN that's why I cannot decide if APU2c4 could handle encryption in case I upgrade Internet speed to 1 Gbit . Suggestions to low power alternatives will be welcome too

Regards,
Jorge