OPNsense
  • Home
  • Help
  • Search
  • Login
  • Register

  • OPNsense Forum »
  • Profile of mrunkel »
  • Show Posts »
  • Messages
  • Profile Info
    • Summary
    • Show Stats
    • Show Posts...
      • Messages
      • Topics
      • Attachments

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

  • Messages
  • Topics
  • Attachments

Messages - mrunkel

Pages: [1]
1
17.7 Legacy Series / Re: Problem with IPSec config save on a brand new 17.7.7 installation
« on: October 26, 2017, 05:11:44 pm »
Ok. I found the problem!
Quote
Oct 26 17:05:25 dus-rtr opnsense: /vpn_ipsec.php: WARNING: User mrunkel may not write config (user-config-readonly set)

Sorry to waste your time.

2
17.7 Legacy Series / Re: Problem with IPSec config save on a brand new 17.7.7 installation
« on: October 26, 2017, 05:07:56 pm »
The one "odd" thing I have currently is that my LAN is disconnected as I'm just testing.

3
17.7 Legacy Series / Re: Problem with IPSec config save on a brand new 17.7.7 installation
« on: October 26, 2017, 05:06:46 pm »
Thanks for the quick response!

No, I tried it by checking it and not checking it.

If I click Enable IPsec and click "Save" the page reloads and Enable IPsec is unchecked.

If I click Enable IPsec and then click + to add a tunnel, it still doesn't save.

If I don't click Enable IPsec and click + to add a tunnel, no joy.

4
17.7 Legacy Series / Problem with IPSec config save on a brand new 17.7.7 installation
« on: October 26, 2017, 04:52:15 pm »
Hi there, brand new OPNsense user, but long time M0n0wall user and former employee over at Untangle.  My problem isn't with IPSec, but rather with the WebUI/config.

When I try to configure an IPSec tunnel it doesn't save, even though I get the blue message "The IPsec tunnel configuration has been changed...."  I've looked at /usr/local/etc and ipsec.conf is blank and config.xml contains no references to the data I input.

All other settings did save, so I know it's not a disk writing issue.

Any pointers at what I can look at to figure out the root cause? (ie, where does the GUI code log?)

Pages: [1]
OPNsense is an OSS project © Deciso B.V. 2015 - 2023 All rights reserved
  • SMF 2.0.19 | SMF © 2021, Simple Machines
    Privacy Policy
    | XHTML | RSS | WAP2