Show Posts
1
17.7 Legacy Series / Problem with IPSec config save on a brand new 17.7.7 installation
« on: October 26, 2017, 04:52:15 pm »
Hi there, brand new OPNsense user, but long time M0n0wall user and former employee over at Untangle. My problem isn't with IPSec, but rather with the WebUI/config.
When I try to configure an IPSec tunnel it doesn't save, even though I get the blue message "The IPsec tunnel configuration has been changed...." I've looked at /usr/local/etc and ipsec.conf is blank and config.xml contains no references to the data I input.
All other settings did save, so I know it's not a disk writing issue.
Any pointers at what I can look at to figure out the root cause? (ie, where does the GUI code log?)
When I try to configure an IPSec tunnel it doesn't save, even though I get the blue message "The IPsec tunnel configuration has been changed...." I've looked at /usr/local/etc and ipsec.conf is blank and config.xml contains no references to the data I input.
All other settings did save, so I know it's not a disk writing issue.
Any pointers at what I can look at to figure out the root cause? (ie, where does the GUI code log?)