Messages

Thank you for your response,
Yes, I turned the any-to-any rule into a policy routing rule and I've added an additional pass rule by creating a alias that included to Vlan networks moved that rule above the any-to-any rule under the LAN interface. But when I change my gateway from default to the Group gateway I'm unable to ping any devices that are in those Vlans. I'll send you a example of one of the VLAN rules:

This is a VLAN that I'm unable to ping from the LAN network when I select the group gateway in my LAN - Default Allow LAN to any Rule.

Again thank you for your assistance.

Hello All,
I was wondering if a member could assist me on an issue that I'm having, My network - LAN, VLan 10 & 20 and I've setup my gateway group, but when I go into my LAN interface to change It to the new gateway group my Vlans immediately lose connection an I'm no longer able to ping my Vlans from my local LAN network.

Thanks in advance.

Thank you all for your input. Well I realized that I had my interfaces labled incorrectly and its the LAN interface that I need to swap! So my question is if I switch my lan interface over to a different interface controller should all my vlans, dhcp, etc auto moved over to the new interface? And as always thank you in advance for your input.

Thank you all for your input. Well I realized that I had my interfaces labled incorrectly and its the LAN interface that I need to swap! So my question is if I switch my lan interface over to a different interface controller should all my vlans, dhcp, etc auto moved over to the new interface? And as always thank you in advance for your input.

Hello All, I need to add the following lines to the boot loader config local:

if_re_load="YES"
if_re_name="/boot/modules/if_re.ko"

I know there are 3 ways of doing this but from want I've read using the tunables section is the best and safest way. Can someone give me an examaple on how to actually add the 2 lines above using tunable section? Thanks in advance.

Hello All,
I'm still in the process of learning OPNsense so I have a quick question. I just update my internet connection from 1G to 2G and added a usb-c 2.5 dongle to the opnsense box, If I want to change the WAN interface from using the 1G port over to the 2.5G dongle is it as simple going into the interface under WAN and deselecting enable interface and prevent interface removal, Go to interface assignments and add the new interface into the group and then replace the WAN interface that's already there and input the new Usb-c 2.5 interface?