WAN Failover Gateway

[Bishop527]

Hello All,
I was wondering if a member could assist me on an issue that I'm having, My network - LAN, VLan 10 & 20 and I've setup my gateway group, but when I go into my LAN interface to change It to the new gateway group my Vlans immediately lose connection an I'm no longer able to ping my Vlans from my local LAN network.

Thanks in advance.

[viragomann]

but when I go into my LAN interface to change It to the new gateway group

Did you turn the only one allow-any-to-any rule into a policy routing rule?
If so, this will force any traffic to the stated gateway.

You have to ensure that the policy routing rule is only applied to upstream traffic.
To do this, you can add an additional pass rule for internal destinations only to the top of the rule set.

[Bishop527]

Thank you for your response,
Yes, I turned the any-to-any rule into a policy routing rule and I've added an additional pass rule by creating a alias that included to Vlan networks moved that rule above the any-to-any rule under the LAN interface. But when I change my gateway from default to the Group gateway I'm unable to ping any devices that are in those Vlans. I'll send you a example of one of the VLAN rules:

This is a VLAN that I'm unable to ping from the LAN network when I select the group gateway in my LAN - Default Allow LAN to any Rule.

Again thank you for your assistance.