"
Sorry -- one additional note: I can see the devices under Interfaces\Diagnotics\ARP Table . . . but they don't seem to be editable there either.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / Re: Unable to remove neighbor entry
January 10, 2026, 02:00:52 PM
Good Morning: I'm having a similar and possibly related problem. Just updated to 25.7.10. Saw an indication of one unexpected error during the update, but then got an indication that the update completed successfully. I had set my devices up with static IP addresses in the prior version. The interface seems to have changed substantially, but in the 25.7.10 under Interfaces\LAN the IPv4 config type is set to "Static IPv4."
My devices now seem to be listed now as "neighbors" and appear to be working. But I believe there was a name field or similar before, where now there's only a description. The devices are all listed as dhcpd-lan, and, for exmaple, my Ecobee thermostat description now says "Living Room" (I think the name field Id'd it before as a Thermostat). This leads to several questions:
1. Am I still running static IPs as before?
2. If not, do I have to reset each device as static, and where/how do I do that?
3: The Neighbors page doesn't seem to allow me to change the description to be more, well, descriptive (if we're ditching the name field), and I thus far can't find a way to do that.
4.
4. It's now unclear how I distinguish between static and DHCP addresses, and how I swap a DHCP entry to a static address -- which, once I looked around the interface, seemed relatively straightforward in the prior version. I could see everything, set static addresses, and then look at something like the neighbors list to
Seems likely I'm just going something wrong. Looked for a log entry after the reported error during the update and didn't find a thing. Currently stumped.
Things seem to be working fine thus far, so this seems relatively minor. But it would help to know if I'm just struggling with the new interface or if there's an issue. If the latter, happy to report whatever is useful -- but somebody will have to tell me what to look for in info that would help.
Thanks much for any help.
My devices now seem to be listed now as "neighbors" and appear to be working. But I believe there was a name field or similar before, where now there's only a description. The devices are all listed as dhcpd-lan, and, for exmaple, my Ecobee thermostat description now says "Living Room" (I think the name field Id'd it before as a Thermostat). This leads to several questions:
1. Am I still running static IPs as before?
2. If not, do I have to reset each device as static, and where/how do I do that?
3: The Neighbors page doesn't seem to allow me to change the description to be more, well, descriptive (if we're ditching the name field), and I thus far can't find a way to do that.
4.
4. It's now unclear how I distinguish between static and DHCP addresses, and how I swap a DHCP entry to a static address -- which, once I looked around the interface, seemed relatively straightforward in the prior version. I could see everything, set static addresses, and then look at something like the neighbors list to
Seems likely I'm just going something wrong. Looked for a log entry after the reported error during the update and didn't find a thing. Currently stumped.
Things seem to be working fine thus far, so this seems relatively minor. But it would help to know if I'm just struggling with the new interface or if there's an issue. If the latter, happy to report whatever is useful -- but somebody will have to tell me what to look for in info that would help.
Thanks much for any help.
Pages1
