Messages

bump.. I have watched multiple youtube videos and the wiki here, but something is escaping me.

I am having the same problem ... and I have to start from scratch each time because I break something and everything stops working..

Did you ever find a resolution ...

New to OPNsense and Zerotier.  Having a problem can't seem to solve.  Zerotier connects to OPNsense fine.  I put in a ZeroTier route to OPNsense LAN subnet.  Enabled "Allow Ethernet Bridging" in Zerotier.  I made a Zerotier interface in OPNsense locked it static (ZeroTier IP for that connection).  Also made a inbound and outbound firewall rule on OPNsense and allowed global IP on ZeroTier client.

But some reason I can only get to routers IP on that subnet from ZeroTier client.  What am I doing wrong? 

did you ever get a resoution for this, as I am stuck with the same issue ...

Hi, anyone ever get an answer for this one?

I am able to ping my ZT peers with an SNAT setup on my Opnsense config.

Firewall --> Automation --> Source NAT

Interface --> ZT Interface
Source --> any
Destination --> any
Translation/Target --> ZT Interface IP

Then define firewalls rules on ZT interface

Hi, I was wondering if anyone knows where to look? I installed zerotier on my OPNsense box.

I can connect from my phone to my home network no issue. I can connect to opnsense and all devices behind it.

However, i cannot connect from my Lan behind my firewall to any of the Zerotier devices? I can ping them from the opnsense box, but not from my PC.

I have seen many posts but no answers. I also created a gateway from the Zerotier interface and tried to do a manual route but this did not work, it actually dropped my internet for some reason.

I suspect My firewall is somehow blocking or not routing the traffic from my lan to zerotier.

i did setup the managed routes, *.*.*.* via lan (Auto setup by zerotier)
10.0.0.0/24 via OPNSense IP.

I noticed on OPnsense under zerotier Networks, it shows the routes however it shows *.*.*.* via but blank does not show Lan.

Im a noob so apologies if this has been answered before.

I am able to ping my ZT peers with an SNAT setup on my Opnsense config.

Firewall --> Automation --> Source NAT

Interface --> ZT Interface
Source --> any
Destination --> any
Translation/Target --> ZT Interface IP

Then define firewalls rules on ZT interface

My struggle is the accessing my LAN peers from ZT ...

Thanks everyone,

i found the solution!

what was the resolution, as I have been facing the same struggle ... ?

I am able to ping my ZT peers with an SNAT setup on my Opnsense config.

Firewall --> Automation --> Source NAT

Interface --> ZT Interface
Source --> any
Destination --> any
Translation/Target --> ZT Interface IP

Then define firewalls rules on ZT interface

My problem is connecting to LAN peers from ZT using Opnsense

I am able to ping my ZT peers with an SNAT setup on my Opnsense config.

Firewall --> Automation --> Source NAT

Interface --> ZT Interface
Source --> any
Destination --> any
Translation/Target --> ZT Interface IP

Then define firewalls rules on ZT interface