Messages

OpenVPN Connect  3 does not work at all. The log say Frame=512/2112/512 mssfix-ctrl=1250 and the app closes without an error on Windows 11 and with a error on Windows 10.

OpenVPN 2.6.6 GUI Community did work after I added "providers legacy default" as a new line config.

thanks

one more pic

I am trying to block access within my net work. The default allow rule seems to override my block. What am I doing wrong see my setup below. I tired resetting my state table but that did not help. Thanks I am pulling my hair out.

I fixed it

1: I unchecked Disable Gateway Monitoring in the gateway settings.

2: Somehow the dpinger Gateway Moniter (staticIp) service was turned off. I turned it on.

3: I checked Disable Gateway Monitoring in the gateway settings.


After I turned it on it now does not even show up in the Lobby: Dashboard. But my issue is fixed

What does the interface summary show? Can you ping your ISPs default gateway?

I cannot ping the ISPs default gateway. It is showing red.

In the firewall log I am seeing. default deny / state violation rule

Static IP from my ISP no DHCP from provider. I had to manual enter IP. I have a fiber modem from ISP.

Ethernet with static addresses and DHCP. No PPPoE. Ethernet is not the issue. My OPNsense box cannot connect to the WAN at all. But I do have Ethernet I think.

Everything was running I clicked upgrade an now no connection.

I updated from 23.1 to 23.1.11 and my lost internet connection. I am trying to work though why. Everything seems to be set up correctly. I am not sure what is going on. 

Here is my experience with this plugin. Trying to connect a APC SRT1000RMXLA-NC

1: Direct connection via USB works.
2: Connecting via USB and setting up a master/slave setup did not seem to work at least not with the truenas-core APCUPSD-UPS client.
3: Connecting via smart card with ethernet also failed to function.

After trying every combination multiple times I gave up after 6 to 8 hours.