"
After this I'm unable to run make install again.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Virtual private networks / Tailscale installation not succeeding
January 15, 2023, 02:11:37 PM
I installed opnsense twice on completely different machines. One was VM in Proxmox and other was baremetal. Both had the same issue. Installing tailscale package by following the instructions in: https://tailscale.com/kb/1097/install-opnsense/ resulted in the installation being stuck in phase:
"tun0: changing name to 'tailscale0'
After manually ending the installation (ctrl+c) I can authenticate tailscale installation normally but can't access web gui. There are no interfaces or firewall rules created automatically.
Could a reason be that at both times I tried to install tailscale before running first run wizard?
- How to fix this?
- How to access opnsense shell from web gui?
"tun0: changing name to 'tailscale0'
After manually ending the installation (ctrl+c) I can authenticate tailscale installation normally but can't access web gui. There are no interfaces or firewall rules created automatically.
Could a reason be that at both times I tried to install tailscale before running first run wizard?
- How to fix this?
- How to access opnsense shell from web gui?
Pages1
