Messages

Ich habe genau die Probleme gehabt, habe dann  UFS, und es läuft. Habe auch ein pfSense 2.7.2 mit ZFS, die probleme gibt es nicht.

It does not work as in manuals, imported ssl ca, and does not work with clamav. Somethimes yes, sometimes not.

[No comment on this.]

"I think at this point you're just trolling. My last reply here if you don't want to heed the documentation AND complain about things. A lot of people are here to get help and that's what we want to keep doing here."
No comment on this.
We were here for that, to get help.
I am very happy actually that you developed opnsense, and the first choise since than was always opnsense for me and my customers. But it seems it is better not to comment or criticise here.
Thx franco.

I aprreciate also their work, but, and i have already spended , not once , if OpnSense CE is a test platform i would like to know that.
Next problem, PPPoE "put zero" , you put Zero 0, and nothing happens, with two zeroes 00 is ok. I mean, those are basic things.Than German Telekom, you make a VLAN 7 Interface, pppoe, with a modem, and it does not connect at all, no logs.
Next: VoIP, never ending story. And i think that OPNSense and PFsense, both does not clear rules really, i am talking because of VOIP, someone suggested only outbound rule to your Voip server, i deleted all rules than make only that, rebooted, and it worked, new installation, just one rule, does not work.
I would really buy a Software, but, "you did not read good you book" is a little arrogant.

Sind immer probleme, 2023 immernoch leider.
Probiere das hier wie im Bilder angezeigt

Thx, i already tried all that.With monitoring, without, IPv6 Proton gateway disabled, enabled ..
What helped for me, opnsense completely reset, and completely new configuration all of the settings.

I didn't say it is not working, but in the interface shows "failed". ProtonVPN TCP das not connect at all here.

Hmmm, it worked before 23.1.7_3, so i followed documentation. And nobody argues here, we are only telling you the problems that we have.

OpenVPN as Client with ProtonVPN:
Connected but Status "failed"
Can this be a cicada-theme problem?

Why not use it? I bought a book OPNsense Praktiker, there is a lot about Management Interface, and will recommended to make a Management Interface.
And i tried the same , than i switched back to listen to all interfaces, and "Error 503". what is helping is only manualy restart from SSH.

If so, than remove that option "Listen interfaces"

What about openvpn client.
Cannot open TUN/TAP dev /dev/tun1: Device busy (errno=16)
must always kill pid

f

Also at All-Inkl.com does not work, why is OPNSense so buggy?

i have tried all of those settings, NO LAN2LAN. Nothing works, i think wireguard is not mature ebough. OpenVPN and IPSec TOP. I have enaogh from Wireguard! Only testing and hoping that is working.