Messages

Hi guys,

Just have a small issue with a Open VPN site to site setup I have.

I have setup a tunnel that is working well and I can see resources on both the remote and server end local networks fine.

The remote end can access the internet but shows it's WAN address rather than the server WAN address which is what I am trying to achieve.   I am a bit of a newb to VPN's so to get this far is pretty good for me.  I am just wondering if you guys could shed some light on how I can force all internet traffic from the remote end down the tunnel and have the remote end show the same WAN address as the server internet WAN address.

To put some perspective on it, I have an office overseas and would not only like to be able to access resources on my local network back home, but also appear that I am at home in terms of WAN IP.

Any help much appreciated.

Oz

Hi guys,

I have previously had a VPN tunnel set up with IPsec Xauth PSK.

I have tried to change it to MSCHAPv2.

When I go through the configuration and setup the Phase 1 entries, it doesn't give me the option to setup Phase 2 entries anymore.  The + symbol is showing for Phase 1 but not Phase 2 and there is no option after configuring Phase 1 to add the Phase 2 entries.

I upgraded from 21.7 this morning to 22.1.6.  The previous version what what I first setup my VPN on.

Not sure if it is a bug or whether there is something amiss in my configuration.

Thanks