Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ZidooNewbie22

#1
Hi @SimHat,

I am looking for a solution for the very same problem as you have.
Other threads related to that topic I found are:
https://forum.opnsense.org/index.php?topic=26694.0
https://forum.opnsense.org/index.php?topic=25868.0
https://forum.opnsense.org/index.php?topic=32006.0
non of them had a solution documentated for this topic.

So in case it helps to debug or support with this , attached you can find screenshots of my rules and NAT configuration.

One remark:  I disabled the WAN rules to support Port Forwarding to reverse proxy, since I only want to allow to access it only from within the LAN  or via OpenVPN, but not from the internet.

Thanks in advance,




#2
Hi,

is it possible to open settings pages by using URL parameter to pre-define some setting values?

This could be handy when makeing notes to re-setup your environment from scratch or when sharing setting configurations for specific areas only.

Attached is a mockup with an example:
#3
Hi There,

I recently set up my opnsense box.  And I need to say I am blown away by this great piece of software. Thanks for your great work.

Regarding a device I own, there was a poor identification of the manufacturer, which I thought it was a device issue:
Quotewhen I going to set a fixed lease for my zidoo Z10 Pro I realized, it was identified by my router as IEEE Registration Authority. - see screenshot last entry

Would be nice if this could be changed to something zidoo related, if it is not hardcoded in the hardware.

A reason the device was identified was brought up by pcristi >> Seems like there are multiple identifiers:
QuoteMany device(router) use only first 3 group(OUI 800a80) to get vendor this will show "IEEE Registration Authority" for Zidoo devices MA-M block (800A805)

So currently OpnSense displays the 80:0A:80 MA-L (Mac Address Block Large (previously named OUI))

Does it make sense to extend the MAC Address identification up the  80:0A:80:5 MA-M (Mac Address Block Medium) ?

Here both of them are displayed next to each other:
https://mac.lc/address/800a80

It's a repost of https://forum.opnsense.org/index.php?topic=26344.msg127115#msg127115
#4
Hi There,

I recently set up my opnsense box.  And I need to say I am blown away by this great piece of software. Thanks for your great work.

Regarding a device I own, there was a poor identification of the manufacturer, which I thought it was a device issue:
Quote
when I going to set a fixed lease for my zidoo Z10 Pro I realized, it was identified by my router as IEEE Registration Authority. - see screenshot last entry

Would be nice if this could be changed to something zidoo related, if it is not hardcoded in the hardware.

Using latest beta firmware currently 6.3.66. Had 6.2 installed until a week ago.
,
http://forum.zidoo.tv/index.php?threads/network-identifier-ieee-registration-authority-zidoo-visibility-in-your-router.92626/#post-167991

Seems like there are multiple identifiers.
Quote from: pcristi, post: 168025, member: 6269Many device(router) use only first 3 group(OUI 800a80) to get vendor this will show "IEEE Registration Authority" for Zidoo devices MA-M block (800A805).

Does it somehow make sense to show additional ones?


Might be a stupid question, but I just curious,

Cheers,